Ph.D. (2015)
National Institute of Technology, Warangal, Telangana
M.E. (Mech Design Engg.) (2006)
Shivaji University, Kolhapur
B.E. (Automobile) (2001)
Shivaji University, Kolhapur
Teaching Experience
2005
Rajarambapu Institute of Technology, Rajaramnagar
2003-2005
Shri. Sueshdada Jain College of Engg. Jalgaon, July 2003 – July 2005
2002-2003
Rajarambapu Institute of Technology, Rajaramnagar
Industry Experience
2001-2002
DuroShox Pvt. Ltd., Sanaswadi, Pune
The primary objective of the present thesis is to perform fundamental numerical studies on the problem of conjugate mixed convection with surface radiation from the geometry of a vertical channel. The investigations have been carried out keeping the cooling of electronic equipment and devices as a potential practical application. An exclusive computer code in C++ has been written to solve the problem considered.
“Stress Analysis and Weight reduction of lower control arm of Mc-Phursun strut suspension system” The lower control arm of Mc-Phursun strut suspension system of Maruti Omni is taken for the analysis.The software to be used for the analysis are Pro-Mechanica and Ansys. The stress pattern was studied and the weight reduction is carried out by optimization techniques and the re analysis is done for the optimized lower control arm. 7% weight reduction is achieved and the overall stresses are reduced from region of higher values of stress.
“Microprocessor controlled fuel injection to two stroke Engine” The carburetor of Scooter is replaced by the use of direct fuel injector which is controlled electronically by the microprocessor. It increases the efficiency of the engine to a greater extent and also reduces the level of exhaust emissions from the two stroke scooter engine.